Tests in this feature area might have additional documentation, including prerequisites, setup, and troubleshooting information, that can be found in the following topic(s):įor generic troubleshooting of HLK test failures, see Troubleshooting Windows HLK Test Failures. Verify that the device boots to desktop with debugger session running Test details
Open WinDBG on debugger machine & open a serial kernel debugger sessionģ.Ĝheck debugger session for output from device while it bootsġ. Run Config_KDCOM.bat file to enable serial mode debugging or run the following commands from an administrative command prompt on the device under test:īcdedit -set dbgtransport kdcom.dllīcdedit /dbgsettings serial baudrate:115200 debugport:1ģ.Ĝonnect the debug board to the pc using debugger cable (micro usb)ġ. If your serial port is not female, convert it by taking a female/female cable or gender changer and plugging it into the serial port.Take a metal paperclip or wire and cross pins 2 and 3. On device under test, flash firmware, install full OSĢ. This is a manual test & it should be run outside HLK by following the manual instructions provided below.ġ.
0 kommentar(er)
